BGR Bundesanstalt für Geowissenschaften und Rohstoffe

Quantitative exploration of aquifer systems – Improvements of the surface nuclear magnetic resonance application

Begin of project: January 1, 2009

End of project: December 31, 2013

Status of project: December 31, 2013

NMR-Messung auf LangeoogNMR-Messung auf Langeoog Source: BGR

The geophysical application of surface nuclear magnetic resonance (surface NMR) measures the distribution of volumetric water content in the subsurface non-invasively. Moreover, using the NMR relaxation times a proxy for the mean pore size is provided that allows the lithological characterization of the subsurface and, if sufficient calibration data is available, the estimation of hydraulic conductivity. However, the application of the surface NMR method suffers in practice from very low signal voltages (10 to 1000 nV) and thus from high sensitivity to the surrounding electromagnetic (EM) noise conditions. The development of multi-channel measurement equipment (Walsh, 2008; Dlugosch et al., 2011) was a breakthrough in the research field of surface NMR, because this technology allows remote references for online detection of surrounding noise. This additional data can be used for predicting the noise signal in the NMR channel and thus for cancelling noise much more effectively than common bandpass or notch filters. The objective of this research project was to test and assess the new technical improvements and to generate further development for optimized usage of the multi-channel technology.

Within the scope of this project different EM noise features were investigated and strategies to remove them from surface NMR signals were developed and tested. Harmonic disturbances from power lines or railways could be cancelled out very successively. Depending on the specific measurement location, a decrease of noise level by a factor of up to 20 could be observed. However, our findings also showed that the individual noise characteristics at the site of investigation require an individual post-processing strategy for realizing the most effective noise minimization. At many places we observed strong variations in frequency or amplitude of the harmonic noise within short periods of time (less than 100 ms) or very short noise signals with enormous amplitudes (spikes). Both features can limit the application of the remote reference technique and must be considered if present. In cooperation with our colleagues at the Leibniz-Institute for Applied Geophysics, we developed optimized noise cancellation strategies for both spiky noise and harmonics with strong temporal variations (Fig. 1, Costabel and Müller-Petke, 2014; Müller-Petke and Costabel, 2014). The developed processing software has been made available to the scientific community by including it into the software package MRSmatlab (Müller-Petke et al., 2012, 2016).

Zwei Datenbeispiele zum Nachweis von Wasser in der ungesättigten Zone mit Oberflächen-NMRAbb.2: Zwei Datenbeispiele zum Nachweis von Wasser in der ungesättigten Zone mit Oberflächen-NMR: (a) Datenbeispiel aus dem BGR-Testgebiet Nauen/Barnewitz, (b) Datenbeispiel aus dem Untersuchungsgebiet des BGR-Projektes FLIN Source: 2a: nach Costabel und Günther (2014), 2b: BGR

In addition to the common application of surface NMR for aquifer characterization, we tested the method and the novel data processing strategies for moisture investigations in the vadose zone. Surface NMR signals from unsaturated materials are even weaker than usual with less than 10 ms and thus, the use of surface NMR measurement for characterizing the vadose zone was limited so far. Within this project, we successfully measured partially saturated regions in the vadose zone (Fig. 2, Costabel and Günther, 2014). Future research is planned to establish the surface NMR method for characterizing the vadose zone and to develop the corresponding interpretation of surface NMR data.

References:

  • Costabel S. und Müller-Petke M. (2014). Despiking of magnetic resonance signals in time and wavelet domain. Near Surface Geophysics 12(2), 185 – 197.
  • Costabel, S., und Günther, T. (2014). Noninvasive Estimation of Water Retention Parameters by Observing the Capillary Fringe with Magnetic Resonance Sounding. Vadose Zone Journal 13 (6).
  • Dlugosch, R., M. Müller-Petke, T. Günther, S. Costabel, and U. Yaramanci (2011). Assessment of the potential of a new generation of surface nuclear magnetic resonance instruments. Near Surf. Geophys. 9, 89 – 102.
  • Müller-Petke M. and Costabel S. (2014). Comparison and optimal parameter setting of reference-based harmonic noise cancellation in time and frequency domain for surface-NMR. Near Surface Geophysics 12(2), 199 – 210.
  • Müller-Petke, M., Walbrecker, J., Hertrich, M. (2012). MRSMATLAB2.0 – Modules for MRS modeling inversion and data processing. MRSMATLAB2.0 – Modules for MRS modeling inversion and data processing. 25th Symposium on the Application of Geophpysics to Engineering & Environmental Problems, Tucson, Arizona.
  • Müller-Petke, M., Braun, M., Hertrich, M., Costabel, S., and Walbrecker, J. (2016). MRSmatlab – A software tool for processing, modeling, and inversion of magnetic resonance sounding data. Geophysics 81 (4), WB9 – WB21. Doi: 10.1190/GEO2015-0461.1.
  • Walsh, D. (2008). Multi-channel surface NMR instrumentation and software for 1D/2D groundwater investigations. Journal of Applied Geophysics, 66(3-4), 140–150.

Posters and Presentations:

Contact:

    
Dr. Stephan Costabel
Phone: +49-(0)30-36993-391
Fax: +49-(0)30-36993-100

This Page: